FactoryZ Surron Waffle Grips

These Surron grips swap the stock rubber for a softer waffle compound that grabs better and soaks up trail chatter before it reaches your hands. They push onto the stock bar and throttle tube on Surron, Talaria, Eride Pro, Stark Varg, and most other e-motos. Black or red, sold as a pair.

Specs:

• Waffle pattern - deep grip under gloves.
• Softer compound than stock - built-in absorption takes the sting out of bumps and holds comfort on long rides.
• 115mm length - full coverage for your whole hand.
• 7/8 inch inside diameter on the clutch side - slides onto the stock bar.
• 1 inch inside diameter on the throttle side - slides onto the stock throttle tube, no trimming.
• Closed ends - trim the end cap to run bar-end weights.
• Push-on install - grip glue recommended so the grips never twist.
• Sold as a pair - one clutch-side grip, one throttle-side grip.

Fits these models:

• Surron Light Bee (all years; also sold as Segway X160 / X260)
• Surron LB2
• Surron Ultra Bee
• Surron Hyper Bee
• Talaria X3
• Talaria MX3
• Talaria MX4
• Talaria MX5
• Eride Pro S
• Eride Pro SS 2.0
• Eride Pro SS 3.0
• Eride Pro SS 4.0
• Eride Pro SR
• Eride Pro Mini
• Stark Varg MX
• Stark Varg EX
• Stark Varg SM
• Tuttio Soleil 01
• Strike Shadow
• Yozma IN 10
• Yozma IN 10 PRO
• Yozma IN 11
• Valtinsu EM-5
• Valtinsu EM-5 PRO
• SRPNT X3
• SRPNT X8
• SRPNT Z27
• ETM RTR Lite, Sport, and Alpha
• Rawr Mantis X
• Macfox X1
• Macfox X1S
• Macfox X2
• Macfox X7
• Ridstar Q20
• Ridstar Q20 Pro
• Ridstar E26
• Zooz Ultra Urban
• Freego X1
• Freego X2 Pro
• Freego X3 Pro

Also fits any dirt bike with a 7/8 inch bar and a 1 inch throttle tube.

Does NOT fit: Super73.

Surron Waffle Grips FAQ

Will these fit my bike?

Yes, if your bike runs a standard 7/8 inch bar and a 1 inch throttle tube. That covers every bike listed above, plus most dirt bikes. The Super73 is the exception.

Why are the two grips different sizes?

The clutch-side grip goes straight on the bar, so it measures 7/8 inch inside. The throttle-side grip rides on the throttle tube, which is larger, so it measures 1 inch inside.

How do they compare to stock grips?

Softer and grippier. The compound absorbs the small hits that numb your hands on stock grips, and the difference shows up on long rides. The waffle pattern keeps a solid hold through gloves.

Can I run bar-end weights?

Yes. The ends ship closed. Trim the end cap off with a sharp blade and the bar end bolts through.

How do I install them?

Cut or pull off the old grips and clean the bar and throttle tube. Add a thin coat of grip glue, slide each grip on, and let it set before riding.

What comes in the box?

One pair of grips: one clutch-side grip and one throttle-side grip. Grip glue is not included.

Ships from USA!